I had bought the hardware in October 2018 and only created a heading for this post. After Siegfried pointed out a problem, I was only too happy to finally fill this post with content and bring the project to completion. After three months of putting it off, I have this...
Continue reading "ESP8266 Bunte Wetterstation AZSMZ V1.8"
When I saw this add-on board, I wondered what the point was when there's already an add-on board with 8 RGB LEDs, which is much more versatile. Is it the lower price or simple purism? Facts An RGB LED Description Name D1 ESP32 C3 S2 RGB Pin D2 4 21 8 33 D1 Mini Shield – …
Continue reading "D1 Mini Shield – RGB LED (Einzeln)"
Heltec offers a low-power board with LoRa in a miniature format here. The price is around €13 on the usual platforms. What is a preview: As I am increasingly losing track of ordered hardware, I will write a small preview after ordering. When I get to the hardware, I will then...
Continue reading "Preview – Heltec Cube Cell Board mit LoRa Wan"
Here is a round display, with 240 x 240 pixels. What is a preview: As I am increasingly losing track of the ordered hardware, I will write a small preview after ordering. When I then get to the hardware, I will replace the corresponding preview with the actual post. This way, you will receive the...
Continue reading "Preview – Rundes1,28 zoll TFT LCD Display"
7 RGB LEDs arranged in a circle, each LED can display 24-bit RGB colours and each LED can be switched individually. Facts 7 RGB LEDs arranged like a flower, LED individually controllable. Description Name D1 ESP32 C3 S2 Signal pin (pre-assigned) D4 GPIO2 16 6 16 Circuit diagram Compatibility D1 Type Compatible Reason if not D1 mini Yes D1 ...
Continue reading "D1 Mini Shield – RGB LED"
Additional board with three connectors for connecting a TFT display, the I2C bus and an I/O device. Facts TFT socket I²C socket I/O socket TFT socket Connection Pin Description Name D1 ESP32 S2 C3 1 Backlight TFT_LED NC 2 Ground GND GND 3 Reset TFT_RST RST 4 Register Select TFT_DC D8 15 5 A5 / 5 …
Continue reading "D1 Mini Shield – I2C Connector"
An 8x8 LED Matrix in red. Facts 8x8 LED Matrix (One module) Data and clock lines are fixed and cannot be adjusted via solder bridges Description Name GPIO Clock CLK 14 Data DIN D7 Schematics Compatibility D1 Type Compatible Reason if not D1 mini Yes D1 mini Pro Yes Not tested D1 mini Lite Yes Not …
Continue reading "D1 Mini Shield – Matrix LED Shield"
I am always surprised that there are still a few readers here on the blog. Recently, Siegfried messaged me and said he wanted to display some bars on a Cristal LCD display, and if I had ever done it before. The answer was no, but that was set to change soon. Facts Parts list Arduino Uno Arduino LCD…
Continue reading "Balken im Crystal LCD Retro Style"
I bought this small package consisting of an ESP01, a control board and an RGB LED ring for around €8 from the large online retailer that starts with an A.
Continue reading "ESP01 – neoPixel Ring"
I've just connected a node to GPS and was looking for some great projects when I found this little beauty. The T-Beam from Lilygo has everything to make a location hunter happy. In addition to GPS, it also has a LoRa chip and a slot for an industrial battery. What more could you ask for.
Continue reading "LilyGo T-Beam"